Trinity stuck in boot-loader mode after bad flashing , pls help

[Goranchen]

Hi to all ,
I have the msn account:*********** .Once again,just to make the resume of the whole story if I remember well:The trinity was with the initial sfr 300+ software(wm5);I installed the oli1.20 flashed it with some other ROM software,did not like it and returned to the original one.Then I tried to flash it with the ROM software where all went wrong...After 1 % the screen went blank and all I can do with the device is to put it into the boot-loader mode where it says:
TRIN100
IPL-0.50
TRIN100
SPL-1.07.0000
When I extracted the file,I discovered that it has 2 nbh-files.I think that is the reason of my defete.Afterwords I have tried all sorts of the first aid solutions : splxploit-windows cannot connect to the device;it says that there is no WCEUS-file and therefore it cannot continue.I have tried to re-flash it through the sd-card:I re-formatted the card on fat32,without any name,put the original ROM and tried to let it boot that way.No success,it marks:loading ... and after 3-4 secs it returns into the boot-loader mode.Salutations frm Luxembourg , Goran Stevanovic.

[boz]

Hi Goran and welcome to 4WM

I have removed your email address or you will be bombarded with spam.

I would leave the Trinity in bootloader maode and reflash the ROM after connecting through your PC, don't worry about activesync it will still connect by USB, it might take a few tries though.